Hello,
Question, have every slot on my 7108 receiver in use, including the SBUS2 for the telemetry (Sparkswitch pro engine data), and planned to use ch8 on the receiver to connect the gain of my iGyro. Unfortunately, this does not work, altough under “servo monitor”, I see the movement when moving the designated control (LS).
When I remove the gain from the receivers’s channel 8, and connect a servo, the servo is also not moving….
What am I doing wrong?
Kind Regards,
Eric
Question, have every slot on my 7108 receiver in use, including the SBUS2 for the telemetry (Sparkswitch pro engine data), and planned to use ch8 on the receiver to connect the gain of my iGyro. Unfortunately, this does not work, altough under “servo monitor”, I see the movement when moving the designated control (LS).
When I remove the gain from the receivers’s channel 8, and connect a servo, the servo is also not moving….
What am I doing wrong?
Kind Regards,
Eric
Kommentar