Hello,
On my jet, I use elevator mixed to the flaps.
So, when lowering flaps, elevator goes down.
Now, I wanted to give the flaps a slower speed, but when I do that,the flaps go down
at a reduced speed, but the elevator not. This would lead to a dangerous situation.
Servo speed was set at 20 for the flaps, in the menu “servo speed”.
Any suggestion to make this possible? I’m looking for the elevator to follow the flaps.
Kind Regards,
ErIc
On my jet, I use elevator mixed to the flaps.
So, when lowering flaps, elevator goes down.
Now, I wanted to give the flaps a slower speed, but when I do that,the flaps go down
at a reduced speed, but the elevator not. This would lead to a dangerous situation.
Servo speed was set at 20 for the flaps, in the menu “servo speed”.
Any suggestion to make this possible? I’m looking for the elevator to follow the flaps.
Kind Regards,
ErIc
Kommentar