Hallo , ich bin gerade dabei meinen ersten Heli zusammen zuschrauben und wollte nun den Gyro von MKS, GY293 einbauen. In der Anleitung steht dann folgender Passus:
5. Connection:
Step A: Link up the rudder server connector to the gyroscope.
Step B: 3Pin connector on the gyroscope is connected to the receiver
(FUTABA is CH4, JR is RUDD).
Step C: The single pin header of gyroscope GAIN connected to receiver
(FUTABA for 5CH, JR for "AUX2" or 3 of AUXs "+").
6. Connecting reference:
GAIN header must be connected to the receiver which has the sensitivity adjust function.
Transmitter GY293 3 Pin connects to the receiver GAIN is connected to the receiver
PPM/SPCM (the model under 9X) "CH4" (RUDD) "AUX2"
FB (1024 serial all model) ,JR 12X JR 12X " CH4" (RUDD) "CH 5"
JR 10X " CH4" (RUDD) "AUX3"
Futaba (T12FG, 12Z, 14MZ series): It is unable to support..
Heist das, die T14,T12 funktionieren nicht mit dem Gyro ? Hat jemand Erfahrung mit dem Gyro ?
LG Uwe
5. Connection:
Step A: Link up the rudder server connector to the gyroscope.
Step B: 3Pin connector on the gyroscope is connected to the receiver
(FUTABA is CH4, JR is RUDD).
Step C: The single pin header of gyroscope GAIN connected to receiver
(FUTABA for 5CH, JR for "AUX2" or 3 of AUXs "+").
6. Connecting reference:
GAIN header must be connected to the receiver which has the sensitivity adjust function.
Transmitter GY293 3 Pin connects to the receiver GAIN is connected to the receiver
PPM/SPCM (the model under 9X) "CH4" (RUDD) "AUX2"
FB (1024 serial all model) ,JR 12X JR 12X " CH4" (RUDD) "CH 5"
JR 10X " CH4" (RUDD) "AUX3"
Futaba (T12FG, 12Z, 14MZ series): It is unable to support..
Heist das, die T14,T12 funktionieren nicht mit dem Gyro ? Hat jemand Erfahrung mit dem Gyro ?
LG Uwe
Kommentar