Rx voltage does not show

[Speedrick]

Hello,

I just binded a 7008sb with my 18SZ, but the tx does not show the rx voltage.
I already re-binded but no change.

Can somebody assist?



Happy newyear!!!!!

Eric

[Stein]

Hi Eric,

Happy New Year...

Please enter the system type menu in your TX.
Check if the RX type is Fasstest and on the right side of the screen there is the function Telemetry, this should be set to ACT.

[tantris]

Hi Eric,

bind again.

Viele Grüsse aus Franken
Hans

[Speedrick]

Hello,

Thanks for the answers!
Unfortunately, no help.... I only have ---
Also, I tried to get the gps alive, but same result, ---
The gps was registered, and indicated in the telemetry list, just no indication��
Binded several times, with no succes...



Kind regards,
Eric

[acid_one]

Hallo Eric,

do you bind the Reciever by Menu or with the Button on RX? Telemetry does only work when RX is bind by Procedure over TX Menu.

Kind regards
Ben

[Speedrick]

Hi Ben,

I tried both ways....



Kind regards,

Eric

[acid_one]

Hi Eric,

then I have no clue! In general this type of Problem means that the RX was bind by Button on RX. In case you need the Manual you find here, binding Procedure you find at Page 43:
http://manuals.hobbico.com/fut/18sz-manual.pdf

kind regards
Ben

[rudi1025]

Binden siehe hier http://www.futaba-forum.net/showthre...ST-Empf%E4nger

lg Rudi

[Speedrick]

Hallo,

In the mean time, I found the answer for the voltage indication, this only works in the Fasstest 12ch mode, not in the 18ch mode. But the GPS should work in the Fasstest 18ch mode, no?

To explained the problem, I took some pic's of the situation. Note that the green light on the gps first blincks green, then goes steady green.

image.jpg
image.jpg
image.jpg

[Speedrick]

As can be found, gps data shows "-------" for every parameter, also for the position.
Any tip for this?



Kind regards,

Eric

[rudi1025]

Binden siehe hier http://www.futaba-forum.net/showthre...ST-Empf%E4nger

LG Rudi

[Speedrick]

Hello Rudi

I'm using an iPad so don't have the FlashPlayer available.
Can you briefly explained (in german language is ok) what I should do?



Thank you!

Eric

[rudi1025]

Hi Eric,

IPad siehe hier http://www.futaba-forum.net/showthre...grammbeispiele

Anmeldung siehe hier http://www.futaba-forum.net/showthre...ensoranmeldung

Lg Rudi